EdgeStar CWD1550W - Page 11

10
Error
Code
Error
description
Unit Action
Possible
Cause
Solution
E30
Door will not
locked after 3
attempts.
Unit will stop
with Error
code display
Door Lock
If the door will not latch, the door lock
assembly might be defective. If the door
won’t latch, check the door to see if the
door is closed before replace it.
PCB
If the washer door will not unlock the
problem might be the main control
board. This is not common. Check the
inner wire between the PCB and the
door lock.
E31
Door will not
unlock after 3
attempts.
Unit will stop
with Error
code display
Door Lock
If the door will not unlock, the door lock
assembly might be defective. If the door will
not latch, check the door to see if the door
is closing properly before replacing door
lock.
PCB
If the washer door will not unlock, the
problem might be the main control
board. This is not common. Check the
inner wire between the PCB and the
door lock.
E33
The main PCB
Is not
receiving the
Water Switch
signal.
Unit will close
valve, stop
motor / pump
and door is
unlocked with
Error code
display
Water level
sensor or
control switch
(No voltage on
the water inlet
valve)
E33 means the unit can’t detect the
Signal of Water level sensor.
CHECK THE WATER LEVEL SENSOR
CHECK THE PCB and the inner wire
between PCB and the sensor
E34
Temp sensor
on water
heater open
cycle
Unit will work
normally
The temp
sensor failed.
The temp sensor failed.
E35
Temp sensor
on water
heater short
cycle
Unit will work
normally
The temp
sensor failed.
The temp sensor failed.