EdgeStar CWD1550W - Page 34

33
Service the Door Lock / Water Heater / NTC
Description
Tools
Needed
Step 1:
Disconnect the
Front panel from
the drum
Find the Spring around the rubber Door Seal and pull it out from the slot.
No tools
needed
Step 2:
Check and
replace the Door
Lock
Remove the 2 (two) screws that secure the Door Lock to front panel.
No tools
needed
Step 3:
Remove the Top
Cover Assembly
Wrench
Step 4:
Remove the
soap drawer /
and drawer sub
assembly and
Control Panel
Subassembly
Refer to “Check
and Replace
PCB’ Steps 2-4)
Phillip
screwdriver
Continued on next page…