Manual Drain
Draining the Unit
The dehumidifier can be drained manually using the water bucket. When
the bucket is full, the unit will automatically stop running, and the wafer full
light will turn on.
Follow the steps fo remove the bucket and dump the wafer.
@
Warning: The wafer produced by
the dehumidifier is not potable or
suitable for drinking.
1) Slowly and carefully pull the
bucket out by the handles until
you see the bucket handle.
2) Pull the bucket up by its
handle
Do not drink the wafer drained
from the unit as if contains
contaminates and could make
you sick.
3) Pour the water out. Do not place the bucket on the floor as its bottom is
uneven and will fall down.
4) Reinstall the bucket.
Continuous Drain
The dehumidifier can be drained continuously fo a floor drain.
]) Remove the water bucket from the unit, and you will find a hose
connector. You can use a ]2 mm hose fo attach fo the connector.
Connector
/
Drain hose
2) Remove the rubber plug from the back of the unit's drain hose outlet,
and push the drain hose through.
3) Securely attach the drain hose fo the connector. Lead the other end of
the hose fo a floor drain or other suitable drainage port.
4) You must reinstall the wafer bucket.
To Next Page
Loading...
