Operating the Control Panel
Power
Use the "Power" button to turn the portable dehumidifier on and off. By
default when you first use the power button, the unit will begin fo operate
in normal fan speed mode.
Note: If the unit was powered off, waif af least 3 minutes before powering
if back on.
Auto-Restart: If power fo the unit is interrupted, the dehumidifier will restart
itself in with the last used mode/settings once the power is restored. The
compressor will restart after 3 minutes.
Auto-Shut Off: The unit will shut off when the set humidify has been
reached, or when the wafer bucket isfull, has been removed, or is not in
its proper position.
Continuous Mode
Continuous mode dehumidifies the air until the wafer bucket is full. Use the
continuous mode for maximum dehumidification. You will not be able fo
use the set humidify buttons.
To operate the unit in continuous mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the "Power" button.
3) Press the "Conf." button. The LED indicator next fo "Conf." will light up.
4) Select the fan speed by using the Normal or High button.
Fan Speeds
The dehumidifier has two fan speeds. Use the turbo fan speed for
maximum moisture removal. Use the normal fan speed for quieter
operation.
Select the fan speed by pressing the "Fan" button until desired mode is
illuminated
Setting the Humidity Level
f
Note: Relative Humidity (RH)is
the ratio of the actual wafer
content of the air at a given
temperature to the potential
water content af fhaf same
temperature.
The desired humidify level can be set within a range of 35% Relative
Humidify (RH) fo 80% RH in 5% increments.
To set the desired humidify level percentage:
]) Make sure the power cord is plugged into a power outlet.
2) Press the Power button. Make sure the "Conf." light is fumed off.
3) Press the "Increase" and "Decrease" buttons fo set the desired humidify
level. After a few seconds, the LCD display will revert fo the acfuat room
humidify level with +5% accuracy. For drier air use the "Decrease" button.