Installation Instructions
f
Note:
Dehumidifiers
working in a
basement will have
little or no effect on
adjacent enclosed
rooms such as
closets, unless there
isenough
circulation of air in
and out of the
enclosed area.
The unit is designed
to work in
environments with
temperatures
between 41°F and
9qOF
Your dehumidifier will remove moisture from the air and collect the excess
wafer in a bucket. You can use the EdgeSfar dehumidifier fo create a
comfortable environment and prevent damage caused by moisture fo
books or valuables in areas such as basements or home libraries. Follow
the instructions below fo unpack and set up your unit.
1) Carefully unpack the dehumidifier from its box and packaging material,
and remove the adhesive tape holding the wafer bucket and filter in
place. You may want fo save the box for storing and transporting the unit.
Let the unit sit upright for af least 24 hours before powering if on fo allow
the compressor's fluids fo settle.
2) Place the dehumidifier on a level floor or surface that is strong enough
fo support the unit with a full bucket of wafer in a room where the
ambient temperature will not drop below 41°F, and away from any heat
sources such as direct sunlight, heaters, radiators, dryers, etc.
Allow at least 10 inches of space all around the unit and at least 20 inches
of space above the unit.
20
10_
f
Caution:
The unit is designed to be used
indoors and freestanding, and
not be used outdoors, or be
built-in fo a cabinet or used
under a counter.
If you have multiple power outlets in the room, choose one that is near the
dehumidifier and fhaf will be able fo provide adequate power fo the unit.
See the power requirements listed on the product label printed on the
side, or on the back of your dehumidifier.
3) Close all windows and doors. To be most effective, use the dehumidifier
in a contained room. For example, use if in a room with four walls and a
ceiling, instead of a partitioned studio, or warehouse.
4) To activate the unit and ensure the warning switches are engaged,
remove the water bucket and reinstall it; otherwise, the unit may not work
properly.
5) Plug the unit in to a grounded outlet. (Read the Safety Information
section.)
6) When first using the unit, press the Power button on the top of the unit
and run if in continuous mode for 24 hours.
To Next Page
Loading...
