6
If your existing Faucet Adapter is not compatible with the “quick connect” hose assembly
supplied, then the following procedures should be followed:
• Connect the Faucet Adapter (included with dishwasher) to your faucet.
• If your faucet is inclusive of a ‘female’ type (threaded) connection, both rubber washers must be
installed inside the faucet adapter.
• If your faucet is inclusive of a ‘male’ type (threaded) connection, use only the standard rubber
washer (0.2”/5mm thick) supplied within the adapter. Remove the second rubber washer.
For Best Results:
Your dishwasher cleans by spraying a mixture of clean hot water and detergent (under pressure)
against the soiled surfaces of dishes. The water is pumped through a rotating spray arm, drained
through a filter (removing food and soiled particles) and pumped back through the spray arm.
Soiled water is pumped out and replaced with clean water at the end of each cycle (the number
of times this is repeated depends on the wash cycle chosen)
Note:
Hard water conditions will adversely affect the washing performance of your dishwasher.
Hard water conditions will also contribute to ‘lime’ (white film substance) deposits and/or
‘scaling’ on the stainless steel surface of the dishwasher tub and heater element, located
in the sump underneath the removable filter screen. To assist in minimizing these
conditions, it is recommended to periodically operate/rinse the inside of the dishwasher
(empty) using one (1) cup of white vinegar at least once a week.
To Next Page
Loading...
Need help?
General
