EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • service@edgestar.com • edgestar.com
Slide the replacement door in the same way the original door was removed
Each side of the lid has a hook built in. That hook needs to slide over the pins on the unit when the
door is slid back into place
Step 5: Reinstall the lid stopping bar
Install the lid stopping bar and tighten the screws
NOTE: Test to verify that the door opens and closes properly before going further. The door can be
tricky to get on the pins and if it does not work, you will have to go back a few steps and try again.
To Next Page
Loading...
