EdgeStar, 8606 Wall St, Suite 1600, Austin, TX 78754
support.edgestar.com • service@edgestar.com • edgestar.com
Step 6: Reinstall the lid handle
Line the handle up with the holes and finger tighten the screws to get them started
With a Phillips screwdriver, tighten the screws the rest of the way
Step 7: Reinstall the top panel of the unit
Slide the front of the top panel under the lid assembly. The panel needs to be slid under at a steep
angle to ensure the lid fits properly behind the lid stopping bar
To Next Page
Loading...
