Adjusting the head with the tool disconnected and not working. Hold the grip ( ref.
1 in fig. 2E ) and handle ( ref. 4 in fig. 1 ) firmly, without touching the on/off button,
and move the head to the required position.
2.05 FORESEEN USE AND RESIDUAL RISKS
The machine may only be used for bending or straightening. The maximum diameter of
the material is 32 mm and its unit tensile strength must not be greater than 750 N/mm².
Do not use the machine for bending other elements that are not specified above.
The machine may only be used if powered by an electrical system compliant with
legislation and current law (suitably connected to an earth system and protected from
current surges and short circuits).
Any use other than that expressly indicated shall be considered as improper and
therefore not permitted.
Edilgrappa S.r.l. declines all liability for any improper use of the machine and for any
modification or change made to it.
Operators must observe the instructions in this manual in order to minimise the risk of
accidents. In particular, they must pay attention when working in conditions that could
cause:
- Possible burns from overheated metal parts;
- Injury due to incorrect positioning or inadequate lifting or moving;
- Injury caused by splinters discharged from the work piece.
People remaining in the vicinities of the machine while it is working are subject to the
following risks:
- flying debris (dangerous objects, etc…);
Hand/arm vibration. Standard applied: EN ISO 5349
The mechanical vibrations transmitted to the hands and arms generate a risk to the
health and safety of workers, especially as concerns vascular, osteoarticular, neurological
and muscular ailments.
The Employer is responsible for assessing the risk generated by mechanical vibrations,
pursuant to Directive 2002/44/EC.
To Next Page