Edimax IC-7010PT User Manual (English)

Other manuals for Edimax IC-7010PT

Questions and Answers:

J
Julia GreenAug 10, 2025
Why is the image refreshing so slowly on my Edimax IP Camera?
- W
  whitekatherineAug 10, 2025
  If your Edimax IP camera's image refreshes slowly, try increasing the frame rate, aiming for 30 if it's lower. Alternatively, reduce the resolution. If you're accessing the camera over the internet, a slow connection might be the cause; consider using a lower frame rate or resolution. Adjust the antenna for optimal wireless reception, ensuring it's perpendicular to the ground and not too far from the access point. Lastly, adjust the 'MTU' setting if you use PPPoE, consulting your ISP or network administrator for guidance.
K
keith15Aug 17, 2025
What to do if Edimax IC-7010PT is not responding?
- S
  Sherry HortonAug 18, 2025
  If your Edimax IP camera is unresponsive, first check the network cable or wireless connection. If those are fine, try unplugging the power adapter from the wall socket, waiting 10 seconds, and then plugging it back in to reset the device.
C
carlshawAug 26, 2025
Why is the image from my Edimax IC-7010PT IP Camera fuzzy?
- N
  Norman CarlsonAug 26, 2025
  If images from your Edimax IP Camera appear fuzzy, begin by adjusting the focus ring until the image sharpens. Clean the lens with a soft, dry cloth, using water if necessary, but avoid alcohol or chemical solutions. Adjust the brightness settings and ensure adequate lighting in the camera's environment.
E
Elizabeth CarterSep 2, 2025
Why are images not being sent by Email or FTP from my Edimax IC-7010PT?
- J
  Jeffrey HornSep 2, 2025
  If your Edimax IP camera fails to send images via email or FTP, ensure that emails aren't being blocked by anti-spam filters. Verify you have sufficient FTP upload permissions by testing with the 'Upload a test file' button. If your SMTP server requires authentication, double-check the username and password using the 'Send a test Email' button. Review the logs for any failed FTP uploads or email sending attempts for clues. You might also try adjusting the threshold to a more sensitive setting.

Edimax IC-7010PT Specifications

General

Model	IC-7010PT
Category	IP Camera
Sensor	1/4" CMOS
Minimum Illumination	0.5 Lux
Day/Night	Yes
IR LEDs	6
IR Range	10m
Frame Rate	30 fps
Network Interface	10/100Mbps Ethernet
Operating Temperature	-10°C to 50°C
Pan/Tilt	Yes
Night Vision	Yes
Sensor type	CMOS
Resolution	1280x720
Lens	3.6mm
Power over Ethernet	Yes
Power Supply	DC 5V
Video Compression	H.264, MJPEG
Operating Humidity	20% to 80%