Send an E-mail notification with picture when
alarm is triggered (motion is detected):
SMTP Server: Input the IP address or host name
of SMTP server (mail server) you wish to use.
Sender: Input the sender’s E-mail address in
sent email. This will help you to identify the
E-mail sent by EdiView. For some SMTP servers,
you must set a sender E-mail address of the
same domain name.
Receiver: Input the E-mail receiver’s address
here.
CC: input additional E-mail receiver’s address
here.
Subject: Input the subject of sent E-mail. This
will also help you to identify the E-mail sent by
EdiView .
Number of attachments: Input the number of
snapshot attachments that will sent with E-mail,
so you can see the image of camera by E-mail (1
to 10 attachments only).
Email alerts Interval: Input the time interval
between two E-mails. A new E-mail will not be
sent within the interval you specified here even
a new event is detected.
User: Input the user name for SMTP
authentication. Input only when it’s required by
your SMTP server, you can leave it blank if it’s
not required.
To Next Page
Loading...
