Network Camera User’s Manual
40/59
Maintenance
1. “Reboot system” The “Reboot” button will reboot the Network Camera. It‘s useful
while the Network Camera got problem.
2. “Restore system” Click on ―Restore‖ button on the configuration page to restore
the factory default settings. Restore all settings to factory default except settings in
―Network type ‖ and ―Root Password‖. The system will restart and require the installer
program to set up the network again.
3. “Calibrate” Recalibrate the home position to the default center to recover the
tolerance cased by some external forces. Please note that there is no confirming
message box after clicking on the “Calibrate” button, the Network Camera will calibrate
immediately.
To Next Page
Loading...
