Edirol FA-66 - Page 27

27
Installing the driver (Windows)
15
A dialog box entitled Welcome to the Found New
Hardware Wizard appears. Make sure that the box
indicates “EDIROL FA-66 Sub 2,” choose “Install the
software automatically (Recommended),” and click
[Next] .
16
A dialog box entitled “Completing the Found New
Hardware Wizard” appears.
Click [Finish] .
The “Found New Hardware” message appears near the
taskbar.
17
In the EDIROL FA-66 Driver Setup dialog box that is
already displayed, click [I Completed the Above Steps] .
The “Found New Hardware” message appears near the
taskbar.
18
The Welcome to the Found New Hardware Wizard
dialog box appears. Make sure that the box indicates
“EDIROL FA-66,” choose “Install the software
automatically (Recommended),” and click [Next] .
19
A dialog box entitled “Completing the Found New
Hardware Wizard” appears. Click [Finish] .
Once again, the “Found New Hardware” message appears
near the taskbar.
This completes driver installation.
A dialog box like the following will appear if “Driver
Signing Options” is not set to “Ignore.”
If a dialog box with the “!” symbol appears...
1. Click [Continue Anyway].
2. Continue with the installation.
If a dialog box with the “X” symbol appears...
1. Click [OK].
2. When the “Found New Hardware Wizard” appears,
click [Finish].
3. Return to step 1 (p. 24), and re-install the driver from
the beginning.
FA-66_e.book 27 ページ ２００６年１月１２日 木曜日 午前１１時３２分