58
Troubleshooting
Did you start up your Macintosh before connecting the FA-66?
If you’re using Mac OS, operation may become unstable if you first connected the
FA-66 to your Macintosh via a FireWire (IEEE 1394) cable and then started up your
Macintosh.
You must start up your Macintosh first, and then connect the FA-66.
Is the FA-66 connected to a FireWire (IEEE 1394) hub?
Try connecting the FA-66 directly to the FireWire (IEEE 1394) connector of your
computer itself.
Noise may be entering via the line inputs or mic inputs.
If a MIDI sound module with a FireWire (IEEE 1394) connector is connected via
FireWire (IEEE 1394) to the same computer as the FA-66, and the output of the MIDI
sound module is connected to the input jacks of the FA-66, noise from the computer
may be heard via the MIDI sound module from the FA-66. In this case, you can
either connect the MIDI sound module and FA-66 in parallel via a self-powered
hub, or connect the MIDI sound module in series or via a MIDI interface.
While you were using the FA-66, could your computer have performed a
task with a heavy processing load, such as accessing a CD-ROM drive or
network?
If a heavy processing load occurs while the FA-66 is being used, it may not work
correctly. In this case, stop playback/recording, and then start playback/recording
once again. If you are still unable to play/record correctly, close all software that
had been using the FA-66, and re-connect the FA-66.
Is the sample rate setting in your software the same as the sample rate
of the digital device connected to the digital input connector?
Set your software and the FA-66 to the same sample rate.
If you switch the FA-66’s sample rate, you must turn the power of the FA-66 off,
then on again to get the setting to take effect.
Playback/recording stops midway, and subsequent playback/recording is
not possible
Digitally recorded sound has distortion, the wrong pitch, or contains noise
FA-66_e.book 58 ページ ２００６年１月１２日 木曜日 午前１１時３２分
To Next Page
Loading...
