A301-05-880 Issue A
Page 18 © Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
Figure 8 - Sight glasses
3.4.3 Gear cover (all EH1200, EH2600 and EH4200 model pumps only)
Use the following procedure to fill the gear cover on all EH1200, EH2600 and EH4200 pumps. Use the same oil that
was used to fill the hydrokinetic drive/gearbox and shaft seal reservoir.
1. Remove the oil filler plug on the top of the gear cover (Figure 2, item 7).
2. Fill the gear cover with oil until the oil level is at the middle of the reflector plate in the gear cover oil level
sight glass (Figure 2, item 9).
3. Refit the oil filler plug.
1. Shaft seal reservoir sight glass
2. Shaft seal reservoir recommended oil level
3. Hydrokenetic drive/gearbox sight glass
4. Hydrokenetic drive/gearbox reflector plate
5. Hydrokenetic drive/gearbox recommended oil level
6. Shaft seal reflector plate
7. Direction of rotation sight glass* (the arrow shows the correct direction)
* Not fitted to EH2600 and EH4200
To Next Page
Loading...
