© Edwards Limited 2015. All rights reserved. Page 11
Edwards and the Edwards logo are trademarks of Edwards Limited.
Technical data
D396-20-880 Issue H
2.6 Factory settings
2.7 Electrical connectors
Note: Do not connect voltages greater than 45 V to the logic interface. If you do, the Controller will not comply
with the low voltage safety recommendations of IEC 1010.
Table 6 - Factory settings
Normal speed 80%
Internal Timer 8 min, enabled
Vent options See Tabl e 9
Analogue output Speed output
Table 7 - Electrical connectors
Electrical supply connector socket type CEE/IEC 320
Earth (ground) stud (on rear panel) M4
Active gauge connector
Signals on the connector pins See Figure 6 and Table 1 1
Socket type FCC68, 8-way
Manufacturer Western Electric
Maximum power 3 W
Logic interface connector 15-way sub-miniature ‘D’ type socket
To Next Page
Loading...
