B756-01-880 Issue K
Page 30 © Edwards Limited 2013. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
7.3.2 Inlet strainer (interstage pumps only)
The EXT70/200Hi and EXT200/200Hi Split Flow Pumps are supplied with inlet strainers for the interstage port. The
Item Number of a replacement inlet strainer is given below.
7.3.3 Inlet flange seals
EXT Split Flow Pumps are supplied with inlet seals. The Item Numbers of replacement seals are given below.
7.4 Accessories
7.4.1 Installation
The accessories available for use with the EXT Split Flow Pumps are described in the following sections. Figure 2
shows how the accessories are fitted to an EXT Split Flow Pump.
7.4.2 EXDC drive modules
Fit an EXDC Drive Module as an alternative to an EXC Controller and pump-to-controller cable.
7.4.3 EXC controllers
The Edwards EXC Controllers provide the facilities necessary for operating a pumping system based on an EXT70/
200H, EXT70/200Hi, EXT200/200H or EXT200/200Hi Split Flow Pump. The Item Numbers of the EXC Controllers are
given below.
Table 9 - Inlet strainer (interstage pumps only)
Flange size Item Number
NW25ISO-K A223-05-067
Table 10 - Inlet-flange seals
Flange size Inlet flange seal Item Number
DN100ISO-K ISO100 trapped O-ring, fluoroelastomer B271-58-171
DN63ISO-K ISO63 trapped O-ring, fluoroelastomer B271-58-170
Table 11 - EXDC drive modules
Drive Module Item Number
EXDC160 24 V 45 deg D396-46-600
*
*
Pump system originally supplied with D396-46-510 (unpackaged)
Table 12 - EXC controllers
Controller Voltage Item Number
EXC100E 90 - 264 V a.c. D396-20-000
EXC100L 90 - 264 V a.c. D396-22-000
EXC120 90 - 264 V a.c. D396-16-000
EXC300 90 - 132/180 - 264 V a.c. D396-14-000
To Next Page
