6. Maintenance
6.1 Maintenance sa
fety
▪ Obey all WARNING and CAUTION instrucons in the Supplementary Publicaon, if
supplied.
▪ A suitably trained and supervised technician must maintain the Vibraon Isolator.
▪ Check that all the required parts are available and of the correct type before you
start maintenance.
▪ Make sure that the technician is familiar with the safety procedures which relate to
the products pumped.
▪ Make sure that you wear the appropriate safety clothing when you come in
contact with contaminated components.
▪ Isolate the system and its components from electrical supply so that they cannot
be operated accidentally.
▪ Do not reuse O-rings and co-seals if they are damaged.
▪ Take care to protect the sealing faces from damage.
▪ We recommend to do a leak test aer installaon is complete to ensure opmum
vacuum performance. Seal any leaks found if any vacuum or exhaust pipeline
connecons have been disconnected.
6.2 Maintenance plan
Sealing and damping O-rings are designed to work properly for 3 years in standard
operang condion. We recommend to check if there are some potenal damping or
leaking issue in your system. Change the O-ring if necessary.
09/2021 - ©Edwards Limited
Page 14B80000860_A
B80000860_A - Maintenance
To Next Page
Loading...
Need help?
General
