Need help?Do you have a question about the Edwards nEXT300 and is the answer not in the manual?
General| Brand | Edwards |
|---|---|
| Model | nEXT300 |
| Category | Water Pump |
| Language | English |
Covers setting power limits and using the standby speed feature for pump operation.
Explains the timer function and the use of analogue output for monitoring pump parameters.
Details automatic vent options and how to set the normal operating speed.
Explains parallel and serial control methods, including combinations.
Covers mixed control modes and detailed controller configuration via serial interface.
Lists detailed technical specifications for nEXT240 and nEXT300 pump variants.
Lists detailed technical specifications for nEXT400 pump variants.
Presents data on continuous inlet flow, backing pressure, and cooling requirements.
Guides on safely unpacking, inspecting, and handling the pump upon receipt.
Illustrates a typical pumping system and provides instructions for connecting the pump to the vacuum system.
Provides methods for mechanically fixing the pump to the vacuum system or a support.
Specifies how to connect the pump's inlet flange and recommended installation orientations.
Covers base mounting procedures and guidelines for connecting the backing port.
Details grounding and connecting the logic interface to TIC or customer equipment.
Provides essential safety warnings and instructions for connecting the pump's electrical supply.
Explains how to connect the pump for parallel control and monitoring using the logic interface.
Details how to establish a serial connection for pump control and monitoring.
Details vent options, connecting vent valves, and their control methods.
Outlines methods for configuring the pump controller settings, via serial commands or TIC.
Details serial commands for setting the power limit and controlling the fan from the controller.
Explains serial commands for configuring automatic vent options.
Covers serial commands for adjusting standby and normal speed settings.
Details serial commands for configuring timer settings and enabling/disabling the timer.
Explains serial commands for configuring analogue output and resetting to factory settings.
Provides essential steps and checks to perform before starting the pump, including LED checks.
Explains how to start, operate at standby speed, stop, and monitor the pump using parallel control.
Details serial commands for starting, setting standby speed, and stopping the pump.
Highlights safety precautions and PPE required for pump maintenance.
Details the service life and replacement recommendations for bearings and oil cartridges.
Emphasizes controller safety and provides a table for identifying and rectifying common faults.
Addresses issues like pump not rotating, high pressure, and contamination.
Covers troubleshooting for noise, vibration, and serial communication failures.
Explains the meaning of LED indicators and how to interpret flashing error codes.
To Next Page