To Next PageTo Next Page
Need help?Do you have a question about the Edwards nXDS6i and is the answer not in the manual?
General| Brand | Edwards |
|---|---|
| Model | nXDS6i |
| Category | Water Pump |
| Language | English |
Covers EMC, RoHS, REACH directives, and material declarations.
Defines hazard notices, safety symbols, and their meanings.
Covers manual scope, ATEX implications, pump description, and controller.
Details the logic interface connector and gas ballast control functionality.
Covers conditions, environment, and general pump performance characteristics.
Details physical dimensions, mass, sound pressure, and vibration levels.
Covers pump construction, electrical ratings, and cable specifications.
Details logic interface signals and the function of LED indicators.
Safety during installation, unpacking, inspection, and pump positioning.
Connecting to vacuum system, electrical installation, and remote control setup.
Describes pump control modes and manual operation via the interface.
Procedures for starting, stopping, and using the pump's standby mode.
Details parallel control, monitoring, and analogue speed adjustment.
Covers analogue control, auto-run settings, and gas ballast usage.
Procedures for pump start-up, achieving vacuum, handling vapours, and shut down.
Safety precautions for maintenance and the overall maintenance schedule.
Instructions for cleaning and inspecting the inlet strainer and fan cover.
Checking performance, replacing tip-seals, and bearings.
Replacing controller, electrical safety, and understanding service indicator codes.
Troubleshooting pump start failures, performance issues, and poor vacuum.
Diagnosing pump noise, high temperature, and interpreting alarm codes.
Guidelines for safely storing and disposing of the vacuum pump.
Information on ordering spares and a list of available accessories.
Details on silencers, gas ballast adaptors, vibration isolators, and filters.
Information on exhaust nozzles, chemical resistance kits, and electrical cables.
Details on pump-to-controller cables, tip-seal kits, fans, and knobs.
Covers spares for filters, bearing replacement kits, and valve kits.
Procedure for returning pumps for service, including contamination forms.
