Edwards nXDS6i User Manual

Table 16 Flashing error codes
Error ash
posion
Error ash
sequence
Comment Acons
0 ssssss Overload meout.
Check whether the pump is not
running under constant high
pressure or the inlet or outlet is not
blocked.
1 Lsssss
Controller soware
error.
Cycle the power to the pump and
see whether the error code appears
again. If it does,contact us or the
supplier.
2 sLssss
Controller failed
internal conguraon
and calibraon
operaon.
Cycle the power to the pump and
see whether the error code appears
again. If it does, contact us or the
supplier.
3 ssLsss Acceleraon meout.
Check whether the pump is not
running under constant high
pressure or the inlet or outlet is not
blocked.
4 sssLss
Over‑current trip
acvated, or other
hardware fault.
Cycle the power to the pump and
see whe
ther the error code appears
again. If it does, contact us or the
supplier.
5 ssssLs Self test fault.
Cycle the power to the pump and
see whether the error code appears
again. If it does, contact us or the
supplier.
6 sssssL
Serial Control Mode
Interlock.
Re‑acvate serial enable and send a
serial command to clear the error
code.
Page 46
A73501880_G - Fault nding

Edwards nXDS6i Specifications

General

Brand	Edwards
Model	nXDS6i
Category	Water Pump
Language	English