What to do if Edwards STP-XA3203BV155 STP pump does not operate correctly after failure?
If the Edwards Water Pump STP pump isn't working correctly after a failure, first ensure the 'ROTATION' LED is off and the pump has stopped. Then, address and eliminate the likely cause of the problem. Next, press RESET to turn off the 'FAILURE' LED, and finally, initiate the START operation.
What to do if Failure LED does not extinguish after RESET operation on Edwards STP-XA3203BV155?
If the Failure LED on your Edwards Water Pump doesn't turn off after a RESET, ensure the STP pump has come to a complete stop. After that, switch the primary power OFF and then switch it back ON.
What to do if the RESET operation does not extinguish the FAILURE LED on Edwards STP-XA3203BV155 Water Pump?
If the RESET operation doesn't turn off the "FAILURE" LED on your Edwards Water Pump, ensure the pump has stopped. Then, switch the breaker to the "OFF" position to cut primary power, and then switch the breaker back to the "ON" position to restore power.
What to do if the RESET operation does not extinguish the 'FAILURE' LED on Edwards STP-XA3203BV155?
If the RESET operation doesn't turn off the 'FAILURE' LED on your Edwards Water Pump, ensure the STP pump has stopped. Then, switch OFF the primary power and turn it back ON.
What to do if the 'STATUS' LED flashes red on my Edwards STP-XA3203BV155?
If the 'STATUS' LED flashes red, you should first follow the recommended actions given in Table 37 to address the probable cause of the abnormality. Next, perform the RESET operation to change the 'STATUS' LED to flash green. Finally, perform the START operation to check if the Edwards Water Pump operates correctly.
What to do if 'STATUS' LED doesn't turn green after RESET on Edwards STP-XA3203BV155 Water Pump?
If the 'STATUS' LED does not change to a green flash even after performing a RESET, confirm that the Edwards Water Pump has stopped. Turn OFF the primary power (switch 'OFF'), and then turn it back ON (switch 'ON').
What to do if Edwards Water Pump shows an error?
If the "FAILURE" LED remains on after a RESET, first ensure the STP pump has stopped. Then, turn the primary power OFF and then ON again. After confirming the "ROTATION" LED is off and the STP pump has stopped, address the cause of the abnormality. Next, perform the RESET operation to turn off the "FAILURE" LED. Finally, perform the START operation and check if the STP pump now operates correctly.
What to do if Edwards Water Pump STATUS LED does not change to green after RESET?
If the Edwards Water Pump's STATUS LED remains unchanged after a RESET operation, ensure the STP pump has stopped. Then, switch the primary power OFF and then ON again.
General| Brand | Edwards |
|---|---|
| Model | STP-XA3203BV155 |
| Category | Water Pump |
| Language | English |
To Next Page