To Next PageTo Next PageWhat to do if Edwards Water Pump STP pump does not operate correctly after failure?
If the Edwards Water Pump STP pump isn't working correctly after a failure, first ensure the 'ROTATION' LED is off and the pump has stopped. Then, address and eliminate the likely cause of the problem. Next, press RESET to turn off the 'FAILURE' LED, and finally, initiate the START operation.
What to do if Failure LED does not extinguish after RESET operation on Edwards STP-iS2207C?
If the Failure LED on your Edwards Water Pump doesn't turn off after a RESET, ensure the STP pump has come to a complete stop. After that, switch the primary power OFF and then switch it back ON.
General| Type | Turbomolecular Pump |
|---|---|
| Model | STP-iS2207C |
| Category | Water Pump |
| Frequency | 50/60 Hz |
| Pump Speed | 2200 l/s (N2) |
| Voltage | 200-240 V |
Outlines essential safety measures and precautions for operating the STP pump.
Lists typical technical specifications for the STP pumps, which are not guaranteed.
Presents data on maximum gas flow rates under various cooling water and back pump conditions.
Specifies the required conditions for using cooling water with the STP pump.
General precautions and requirements before installing the STP pump.
Guides on how to unpack and install the STP pump safely.
Step-by-step instructions for installing the STP pump into vacuum equipment.
Covers procedures for gas pumping, cooling, and baking the STP pump.
Provides procedures for troubleshooting immediate failures.
General troubleshooting steps for pump issues and LED indications.
