What to do if the 'STATUS' LED flashes red on my Edwards STP-iXA4507 Water Pump?
If the 'STATUS' LED flashes red, you should first follow the recommended actions given in Table 37 to address the probable cause of the abnormality. Next, perform the RESET operation to change the 'STATUS' LED to flash green. Finally, perform the START operation to check if the Edwards Water Pump operates correctly.
What to do if 'STATUS' LED doesn't turn green after RESET on Edwards Water Pump?
If the 'STATUS' LED does not change to a green flash even after performing a RESET, confirm that the Edwards Water Pump has stopped. Turn OFF the primary power (switch 'OFF'), and then turn it back ON (switch 'ON').
Provides data on maximum gas flow rates and water cooling requirements.
Guides on how to install, connect cables, piping, and specific units like TMS.
Details vacuum piping methods and connecting purge and cooling ports.
Details signal connections, RS485 setup, communication parameters, and ports.
Explains protocol specifications, transmission frames, error control, and data formats.
Lists available commands for pump operation, settings, and reading data.
Explains safety functions for detecting abnormalities/errors and response mechanisms.
Provides guidance on troubleshooting failures indicated by LEDs or errors.
General| Brand | Edwards |
|---|---|
| Model | STP-iXA4507 Series |
| Category | Water Pump |
| Language | English |
To Next Page