© Edwards Limited 2007. All rights reserved. Page 25
Edwards and the Edwards logo are trademarks of Edwards Limited.
Storage and Disposal
A730-01-880 Issue E
6Storage and Disposal
6.1 Storage
Use the following procedure to store the pump:
1. Shut down the pump as described in Section 4.7.
2. Disconnect the pump from the electrical supply.
3. Place and secure protective covers over the inlet and outlet ports.
4. Store the pump in cool, dry conditions until required for use. When required, prepare and install the pump as
described in Section 3.
6.2 Disposal
Dispose of the pump and any components from it safely in accordance with all local and national safety and
environmental requirements.
If this pump is to be returned to Edwards Vacuum Technology for disposal/ investigation. Particular care must be
taken with components that have been contaminated with dangerous process substances.
WARNING
Do not incinerate fluoroelastomer seals, tip seal material and 'O' rings.
To Next Page
Loading...
Need help?
General
