Edwards xds35i

Index
A730-01-880 Issue E
© Edwards Limited 2007. All rights reserved. Page 29
Edwards and the Edwards logo are trademarks of Edwards Limited.
A
Accessories ............................................... 27
ATEX directive implication ...............................2
C
Clean the external fan cover ..........................22
Connect the pump to your electrical supply ........ 13
Construction ................................................4
D
Description ..................................................3
Disposal ................................................... 25
E
Electrical data .............................................7
Electrical installation ................................... 12
F
Fault-finding .............................................. 22
Flammable/pyrophoric materials ..................... 16
G
Gas ballast control ........................................4
Gas purges ................................................16
General characteristics ...................................5
I
Implication of ATEX directive .......................... 16
Inlet and outlet connections ........................... 13
Inspect and clean the gas ballast control ............ 21
Inspect and clean the inlet strainer ..................20
Installation ..................................................9
Introduction ................................................1
L
Leak test the system ....................................14
Locate the pump .........................................12
M
Maintenance .............................................. 19
Maintenance plan ........................................19
Mechanical data ............................................6
O
Operating and storage conditions .......................5
Operation .................................................15
P
Performance characteristics .............................5
R
Remote operation using 15 way D connector ....... 17
Replace the tip seals .................................... 22
S
Safety .......................................................9
Scope and definitions .....................................1
Service .................................................... 27
Shut down ................................................ 17
Spares ..................................................... 27
Start up procedure ...................................... 15
Storage .................................................... 25
System design considerations .......................... 10
T
Technical data .............................................5
Test the motor condition ............................... 22
U
Unpack and inspect ..................................... 12
Use of gas ballast control .............................. 15
V
Vibration data ..............................................6
Index