EemaX AUTOBOOSTER User Manual

REV I – 3/1/2016
INSTALLATION INSTRUCTIONS & HOME OWNERS MANUAL
AUTOBOOSTER™
IMPORTANT SAFETY INFORMATION
When installing or using any high voltage electrical appliance, basic safety precautions should always be
followed. Under no circumstance should you attempt to clean, install, inspect, repair, disassemble or
otherwise service this water heater, without first shutting off all power to the unit directly at the circuit
breaker box. SERIOUS BODILY INJURY OR DEATH COULD OCCUR IF YOU IGNORE THIS WARNING.
IF ASSISTANCE IS NEEDED, A LICENSED AND QUALIFIED PLUMBER AND ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL, STATE, PROVINCIAL, AND LOCAL PLUMBING AND ELECTRICAL CODES
SHOULD BE HIRED.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY AND COMPLETELY PRIOR TO INSTALLATION & USE.
FAILURE TO DO SO COULD CAUSE PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH.
This manual should be shown to all members of the household who plan to use this unit, and be retained for
future reference.
Tested and certified by the Water Quality Association against NSF/ANSI 372 for lead free
compliance.
Downloaded from https://gadgetsgo.com/AutoBooster-HATB007240-water-tank-heater-boost.html Authorized Eemax Dealer

EemaX AUTOBOOSTER Specifications

General

Brand	EemaX
Model	AUTOBOOSTER
Category	Water Heater
Language	English

Summary

IMPORTANT SAFETY INFORMATION

ABOUT YOUR AUTOBOOSTER™

TECHNICAL SPECIFICATIONS

Details voltage, amperage, power rating, temperature ranges, and flow rate.

BEFORE INSTALLATION

What you will need to install

Lists tools and materials required for the installation process.

SELECTING A LOCATION TO INSTALL

SETTING UP TO INSTALL

Recommended Clearances

Specifies required space around the unit for installation and maintenance.

Possible Pre-Existing Plumbing Layouts

Cutting the Copper Hot Water Pipe – Layout A

Cutting the Copper Hot Water Pipe – Layout B

PLUMBING INSTALLATION

Installation Instructions

Connect inlet/outlet, drain, purge air, check leaks, and turn off faucets.

IMPORTANT NOTES

Critical notes on pressure relief valves, water pressure, and shut-off valves.

ELECTRICAL INSTALLATION

Water Pressure and Pipe Ratings

Information on maximum water pressure and pipe temperature ratings.

Installation Instructions (Electrical)

Wiring Connections

How to connect L1, L2, and ground wires for proper function.

Electrical Wiring Diagram

Connection Reference 1

Connection Reference 2

GENERAL OPERATING INSTRUCTIONS

Important Notes (Maintenance)

Safety and operational warnings during maintenance, especially purging air.

MAINTENANCE

TROUBLE SHOOTING GUIDE

USER INTERFACE

Primary Menu Cycle Screens

Explains how to cycle through and view basic operating information.

Active Time & Total Time

Setup & Activation Temperature

Max Temperature

Vacation Mode & Eco Mode

Software Version & Exit