EemaX SP2412 - User Manual

1
INSTALLATION GUIDE AND OWNER’S
MANUAL
“SINGLE POINT”, “FLOW CONTROLLED” and “THERMOSTATIC”
ELECTRIC INSTANTANEOUS WATER HEATERS
BEFORE ATTEMPTING ANY INSTALLATION, MODIFICATION OR SERVICE OF THIS
HEATER, MAKE SURE THE ELECTRICAL POWER IS DISCONNECTED.
Read and understand these instructions thoroughly before attempting the installation or service of this
water heater. Failure to follow these instructions can result in serious injury, death and/or property
damage. The warranty of this water heater will depend upon the proper installation according to these
instructions. Some heaters come supplied with separate faucet aerators. If supplied, the aerator must
be installed in the faucet for optimum performance. This heater must be used to heat water only and
be in a location where it is not subject to freezing temperatures. The manufacturer is not liable for any
damages resulting from improper installation or misuse.
This installation must conform to the latest requirements of the National Electrical Code and all
applicable state and local codes. This information is available through your local authorities. You must
understand these requirements before beginning this installation.
This unit is not required by UL 499 to have a Temperature and Pressure relief valve (T&P). You should
check with local codes to find out if one is required. If it is, it must be installed in the outlet hot water
pipe between the heater and the isolation valve.
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be followed, including the
following:
READ AND FOLLOW ALL INSTRUCTIONS
A green terminal (or a wire connector marked “G”, “GR, “Ground”, or “GROUNDING”) is provided within
the control box. To reduce the risk of electric shock, connect this terminal or connector to the
grounding terminal of the electric service or supply panel with a continuous copper wire in accordance
with your local electrical code.

Summary

Important Safety Instructions

Warning: Disconnect Power

Before attempting installation or service, ensure electrical power is disconnected.

Read and Follow Instructions

Connect the grounding terminal to reduce the risk of electric shock.

General Information and Cautions

Danger: Hot Water Scald Risk

High water temperatures can cause severe burns. Test before use.

Mounting the Unit

Mounting and Securing Steps

Plumbing Hook-Up

Critical Plumbing Cautions

Never use pipe dope/Teflon tape with threaded fittings or solder near heater.

Plumbing Connection Steps

Electrical Hook-Up

Electrical Safety Warning

Ensure breaker is OFF and all mounting/plumbing is complete.

Power and Grounding Connections

Commissioning the Heater

Commissioning Safety Caution

Ensure valves are open, water flows, and heater is not frozen before turning on power.

Commissioning Steps

Setting the Temperature

Temperature Adjustment Method

Heater Type Specific Adjustments

Basic Troubleshooting

Symptom: No Heat, Power Light Off

Symptom: No Heat, Power Light On

Repair Parts

EemaX SP2412 Specifications

General

Voltage	240 V
Phase	Single Phase
Frequency	60 Hz
Protection	Overheat Protection
Material	Copper