What to do if EemaX Water Heater has undervoltage?
If your EemaX Water Heater is experiencing undervoltage, it indicates that the inlet voltage is too low compared to the heater's specifications. Provide voltage within specified range.
Why is my EemaX FlowCo SPEX55 Water Heater producing low heat?
Low heat from your EemaX Water Heater can occur for several reasons: - The outlet temperature is below 90°F/32°C for 5 seconds of flow. - Element failure. - ECO tripped or malfunctioning. - Relay/contactor malfunctioning. - Control board failure. - Inlet water supply out of spec. To attempt a fix, reduce the flow through the unit.
What to do if EemaX Water Heater flow is too high?
If the flow in your EemaX Water Heater is too high, preventing the water from heating to the setpoint temperature, reduce the flow. You can achieve this by using an outlet flow restrictor or a faucet aerator.
What to do if EemaX FlowCo SPEX55 shows freeze warning?
If your EemaX Water Heater displays a freeze warning, it means the inlet temperature is too low (below 35°F). To resolve this, increase the temperature of the inlet water to meet product specifications.
What to do if EemaX FlowCo SPEX55 Water Heater has overvoltage?
If your EemaX Water Heater is experiencing overvoltage, it means the inlet voltage is too high compared to the heater's specifications. Provide voltage within specified range.
What causes residual heat in EemaX FlowCo SPEX55?
Residual heat in your EemaX Water Heater, indicated by an elevated internal water temperature without flow, is caused by both triacs failing closed. To solve this, run water through the unit.
What to do if EemaX Water Heater has inlet thermistor failure?
If your EemaX Water Heater is showing an inlet thermistor failure, this is because the inlet thermistor is interrupted or disconnected. Inspect the connections/wiring of the inlet thermistor.
What to do if EemaX FlowCo SPEX55 has outlet thermistor failure?
If your EemaX Water Heater is showing an outlet thermistor failure, this is because the outlet thermistor is interrupted or disconnected. Inspect connections/wiring of outlet thermistor.
What to do if EemaX Water Heater has over-temperature protection?
If the outlet temperature of your EemaX Water Heater exceeds 130°F/54°C, it triggers over-temperature protection. To resolve this, increase the water flow through the unit. This will help decrease the overall temperature rise.
What to do if EemaX FlowCo SPEX55 Water Heater shows an over-temperature warning?
If the outlet temperature of your EemaX Water Heater exceeds 110°F/38°C, it triggers an over-temperature warning. To address this, increase the flow through the unit. If you desire this temperature, no action is required.
Heater must be installed in a location protected from freezing temperatures.
Details on pressure, flow rate, and recommended fittings for plumbing connections.
Warning against using pipe dope, Teflon tape, and soldering to prevent damage and warranty voidance.
Table of model specifications including voltage, power, current, and wire size.
Emphasizes the critical importance of grounding the electrical system for safety.
Verify water flow and absence of air pockets before energizing the heater.
Part numbers for 3/8" nuts and sleeves used in compression fittings.
General| Brand | EemaX |
|---|---|
| Model | FlowCo SPEX55 |
| Category | Water Heater |
| Language | English |
To Next Page