What to do if EemaX FlowCo SPEX3208 Water Heater has undervoltage?
If your EemaX Water Heater is experiencing undervoltage, it indicates that the inlet voltage is too low compared to the heater's specifications. Provide voltage within specified range.
Why is my EemaX Water Heater producing low heat?
Low heat from your EemaX Water Heater can occur for several reasons: - The outlet temperature is below 90°F/32°C for 5 seconds of flow. - Element failure. - ECO tripped or malfunctioning. - Relay/contactor malfunctioning. - Control board failure. - Inlet water supply out of spec. To attempt a fix, reduce the flow through the unit.
What to do if EemaX Water Heater flow is too high?
If the flow in your EemaX Water Heater is too high, preventing the water from heating to the setpoint temperature, reduce the flow. You can achieve this by using an outlet flow restrictor or a faucet aerator.
What to do if EemaX Water Heater shows freeze warning?
If your EemaX Water Heater displays a freeze warning, it means the inlet temperature is too low (below 35°F). To resolve this, increase the temperature of the inlet water to meet product specifications.
What to do if EemaX FlowCo SPEX3208 has overvoltage?
If your EemaX Water Heater is experiencing overvoltage, it means the inlet voltage is too high compared to the heater's specifications. Provide voltage within specified range.
What causes residual heat in EemaX FlowCo SPEX3208?
Residual heat in your EemaX Water Heater, indicated by an elevated internal water temperature without flow, is caused by both triacs failing closed. To solve this, run water through the unit.
What to do if EemaX FlowCo SPEX3208 has inlet thermistor failure?
If your EemaX Water Heater is showing an inlet thermistor failure, this is because the inlet thermistor is interrupted or disconnected. Inspect the connections/wiring of the inlet thermistor.
What to do if EemaX FlowCo SPEX3208 Water Heater has outlet thermistor failure?
If your EemaX Water Heater is showing an outlet thermistor failure, this is because the outlet thermistor is interrupted or disconnected. Inspect connections/wiring of outlet thermistor.
What to do if EemaX FlowCo SPEX3208 has over-temperature protection?
If the outlet temperature of your EemaX Water Heater exceeds 130°F/54°C, it triggers over-temperature protection. To resolve this, increase the water flow through the unit. This will help decrease the overall temperature rise.
What to do if EemaX FlowCo SPEX3208 shows an over-temperature warning?
If the outlet temperature of your EemaX Water Heater exceeds 110°F/38°C, it triggers an over-temperature warning. To address this, increase the flow through the unit. If you desire this temperature, no action is required.
Key safety precautions and guidelines for operating electrical equipment like this water heater.
Emphasizes the importance of reading and adhering to all instructions before installation or service.
Describes the Eemax FlowCo as a non-thermostatic electric tankless water heater for specific applications.
Details the dangers of hot water, scalding potential, and recommended temperature checks for safety.
Table of LED patterns, status, possible causes, and solutions for common heater issues.
Recommendations for routine cleaning of aerators and filter screens to ensure consistent water flow and performance.
List of part numbers for compression fittings used with the water heater.
Catalog of internal components and their corresponding part numbers for Eemax FlowCo models.
General| Voltage | 240 V |
|---|---|
| Wattage | 3200W |
| Frequency | 50/60 Hz |
| Heating Element | Copper |
| Power | 3200W |
| Protection | Overheat protection |
| Plumbing Connection | 1/2" NPT |
To Next Page