What to do if EemaX FlowCo SPEX2412 Water Heater has undervoltage?
If your EemaX Water Heater is experiencing undervoltage, it indicates that the inlet voltage is too low compared to the heater's specifications. Provide voltage within specified range.
Why is my EemaX FlowCo SPEX2412 Water Heater producing low heat?
Low heat from your EemaX Water Heater can occur for several reasons: - The outlet temperature is below 90°F/32°C for 5 seconds of flow. - Element failure. - ECO tripped or malfunctioning. - Relay/contactor malfunctioning. - Control board failure. - Inlet water supply out of spec. To attempt a fix, reduce the flow through the unit.
What to do if EemaX Water Heater flow is too high?
If the flow in your EemaX Water Heater is too high, preventing the water from heating to the setpoint temperature, reduce the flow. You can achieve this by using an outlet flow restrictor or a faucet aerator.
What to do if EemaX FlowCo SPEX2412 Water Heater shows freeze warning?
If your EemaX Water Heater displays a freeze warning, it means the inlet temperature is too low (below 35°F). To resolve this, increase the temperature of the inlet water to meet product specifications.
What to do if EemaX Water Heater has overvoltage?
If your EemaX Water Heater is experiencing overvoltage, it means the inlet voltage is too high compared to the heater's specifications. Provide voltage within specified range.
What causes residual heat in EemaX Water Heater?
Residual heat in your EemaX Water Heater, indicated by an elevated internal water temperature without flow, is caused by both triacs failing closed. To solve this, run water through the unit.
What to do if EemaX FlowCo SPEX2412 has inlet thermistor failure?
If your EemaX Water Heater is showing an inlet thermistor failure, this is because the inlet thermistor is interrupted or disconnected. Inspect the connections/wiring of the inlet thermistor.
What to do if EemaX Water Heater has outlet thermistor failure?
If your EemaX Water Heater is showing an outlet thermistor failure, this is because the outlet thermistor is interrupted or disconnected. Inspect connections/wiring of outlet thermistor.
What to do if EemaX FlowCo SPEX2412 has over-temperature protection?
If the outlet temperature of your EemaX Water Heater exceeds 130°F/54°C, it triggers over-temperature protection. To resolve this, increase the water flow through the unit. This will help decrease the overall temperature rise.
What to do if EemaX FlowCo SPEX2412 Water Heater shows an over-temperature warning?
If the outlet temperature of your EemaX Water Heater exceeds 110°F/38°C, it triggers an over-temperature warning. To address this, increase the flow through the unit. If you desire this temperature, no action is required.
Ensure electrical power is disconnected before any installation, modification, or service.
Installation must conform to the National Electrical Code and all applicable state and local codes.
Supply appliance from a grounded system, connecting ground terminal with continuous copper wire.
Use an individual branch circuit with insulated, UL-listed 2-wire cable (2 wire plus ground) suitable for 75°C.
Diagnose issues like low heat, thermistor failure, or over-temperature based on LED patterns.
Provides possible causes and solutions for various operational statuses and LED warnings.
General| Brand | EemaX |
|---|---|
| Model | FlowCo SPEX2412 |
| Category | Water Heater |
| Language | English |
To Next Page