EemaX LavAdvantage - Page 6

6
3. Remove the cover. Connect the pre-assembled inlet and
outlet pipes to the heater and fully open the inlet and
outlet ball valves. Check for water leaks. If a leak is at a
compression fitting, slowly tighten the compression nut
until it stops. Replace the cover.
4. Open the hot water faucet and run water for minimum
60 seconds and until the flow is continuous and free of air
pockets. Close the faucet and install the aerator (if
supplied).
Failure to install aerator (if supplied) will result in lower-
than-expected heater performance**.
Model
# of
Aerators
Model
# of
Aerators
SPEX3512T ML
2
SPEX3208T ML
2
SPEX35T ML
2
SPEX4208T ML
2
SPEX48T ML
2
SPEX3277T ML
2
SPEX55T ML
2
SPEX4277T ML
2
SPEX65T ML
2
SPEX60T ML
2
SPEX75T ML
2
SPEX80T ML
2
SPEX95T ML
3
SPEX90T ML
3
SPEX012240T ML
3
SPEX100T ML
3
**ML thermostatic models are designed to deliver a
minimum flow of 0.35 GPM to each lavatory. Please install
the supplied aerators to ensure maximum heating
performance.