This chapter provides recommendations on installing FieldBee and RTK Bee Station.
Most of them are required for proper work and to achieve maximal accuracy.
FIELDBEE INSTALLATION
Requirements
For tractors with plastic roof you will need a metal plate, you can order one at
www.efarmer.mobi/shop
Guide
1. Connect the power cable to FieldBee power socket.
2. If Radio (LoRa) mode is being used - screw in radio
antenna.
3. Install FieldBee on the tractor’s roof as close as
possible to the rear axis on the center line. (See the
picture) For plastic roof use a metal plate to provide
magnetic surface. Antenna back panel with power
button and sockets should face towards the rear end
of the tractor.
4. Lay down the wire through the rear window or
sunroof.
5. Insert power cable to cigarette lighter socket -
FieldBee will power on automatically.
INSTALLATION
DO NOT’S
Do not put
antenna on
the tractor hood
Do not change
orientation of
antenna
Do not put power
cable through
the door
INSTALLATION
To Next Page
Loading...