QS Series Basic Operator's Guide
Startup
Before getting started each day, you will want to spend some
time preparing your printer in order to achieve the best
possible print quality.
1. Power-up the printer.
2. Perform your daily printer maintenance.
3. Ink purge all colors to remove the head conditioner.
4. Wet wipe the jet packs with maintenance fluid.
5. Print a sample jet test.
Information about shutting down and restarting your printer
can be found on page 62.
Powering up the printer
1. Ensure that all the emergency stop buttons are reset
(twist the button counter-clockwise until it pops fully out).
2. Press the power button (located to left of the operator
interface panel).
The power button lights up green, indicating that the
power is on.
3. As the printer powers up, the VUTEk User Interface
(VUI) will start.
If the VUTEk User Interface fails to start, see page
Error! Bookmark not defined. for instructions on how
to start it manually.
OMM-00038-US English-F 9
To Next Page
Loading...
