QS Series Basic Operator's Guide
f Shut off the UV lamps,
f Stop all mechanical movement within the printer,
f Stop the unwinder and rewinder.
The emergency stop buttons do not remove power from the
printer or its electronics.
Never use the emergency stop buttons as an alternative to
powering down the printer when instructed to do so. The
emergency stop buttons are for your personal safety and help
avoid printer damage during extraordinary circumstances.
Restarting the printer after an emergency stop
After eliminating the danger or resolving the problem that
required the emergency stop, you can restart the printer.
1. Ensure that all the emergency stop buttons are reset
(twist the button counter-clockwise until it pops fully out).
2. Press the power button on the back left corner of the
monitor shelf to power down the printer.
3. Press the power button a second time to power up the
printer. The power button lights up green, indicating that
the power is on.
12 OMM-00038-US English-F
To Next Page
Loading...
Need help?
General
