EG4 6000XP GEN BOOST User Manual

©2024 EG4 ELECTRONICS, LLC. ALL RIGHTS RESERVED.
VERSION 1.0 | INFORMATION SUBJECT TO CHANGE WITHOUT NOTICE.
EG4 6000XP GEN BOOST
This document provides a brief overview of the newly added
“Generator Boost” setting via the latest firmware update. This setting
allows the 6000XP to pull supplemental power from both PV and
Battery whenever the generator power is not sufficient to handle all
loads. This setting can be activated via the EG4 Monitor System or the
LCD display.
ACTIVATING GEN BOOST THROUGH EG4 MONITOR CENTER
Follow the steps listed below to activate Generator Boost via Monitor Center:
1. Login to the Monitor Center and select the appropriate station.
2. Navigate to the “Maintenance” tab.
3. Navigate to the “Charge Setting” section.
NOTE: Only installer or distributor accounts are able to
remotely set this function through the EG4 Monitor Center.
Endusers must set this via the LCD display on the front of
the unit.

EG4 6000XP GEN BOOST Specifications

General

Rated Power	6000W
Input Voltage	120/240VAC
Output Voltage	120/240VAC
Efficiency	93%
Model	EG4 6000XP GEN BOOST
Max AC Input Current	50A
Max Charge Current	120A
Max Input Current	18A
Surge Power	12000W
Frequency	60Hz
Maximum DC Voltage	500V
Battery Voltage Range	40-60V
MPPT Voltage Range	120-450V

Summary

Activate Generator Boost via Monitor Center

Monitor Center - Charge and Generator Settings

Navigate to Maintenance, then Charge Setting and Generator Charge sections to configure parameters including Generator Boost.

Activate Generator Boost via LCD Display

Inverter LCD - Navigate and Enable Generator Boost

Access settings via the Enter button, select setting 30 (GEN BOOST), and choose Enable or Disable.