Ego Power+ HTA2000 - Troubleshooting and Warranty; Hedge Trimmer Does Not Work; Excessive Vibration or Noise; EGO Warranty Policy

HEDGE TRIMMER ATTACHMENT — HTA200012
EN
TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION
Hedge Trimmer does
not work.
č The battery pack is not attached to the
hedge trimmer.
č Attach the battery pack to the hedge
trimmer.
č No electrical contact between the hedge
trimmer and battery.
č Remove battery, check contacts and
reinstall the battery pack.
č The battery pack is depleted. č Charge the battery pack.
č The lock-off button is not depressed
before pressing the trigger.
č Press down the lock-off lever and hold
it, then depress the trigger to turn on
the tool.
č The battery pack or power head is too hot. č Allow the battery pack or power head
to cool until the temperature drops
below 152°F (67°C).
č The blade is jammed. č Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
č The hedge trimmer is not well connected
with the power head.
č Disconnect the hedge trimmer from
the power head. Reconnect them
following the section“INSTALLING AN
ATTACHMENT TO THE POWER HEAD”
in PH1400E operator’s manual.
Excessive vibration or
noise.
č Dry or corroded blades. č Lubricate the blades.
č Blades or blade support is bent. č Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
č Bent or damaged teeth. č Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
č Loose blade bolts. č Tighten the blade bolts. Using a 3mm
wrench, (not included), turn the bolt
clockwise to tighten.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.