Ego Power+ HTX6500 - Troubleshooting; Hedge Trimmer Does Not Work; Excessive Vibration or Noise

56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HTX6500/HTX750012
EN
TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION
Hedge Trimmer does
not work.
◾ The battery pack is not attached to the
hedge trimmer or no electrical contact
between the hedge trimmer and battery.
◾ Reinsert the battery plug into the
hedge trimmer.
◾ The battery pack is depleted. ◾ Charge the battery pack with the
specied charger.
◾ The lock button has not pushed to position
“ON” before pressing the switch levels.
◾ Before using the trimmer, conrm the
lock button is unlocked.
◾ The battery pack or hedge trimmer is
too hot.
◾ Allow the battery pack or hedge
trimmer to cool until the temperature
to normal temperature.
◾ The blade is jammed. ◾ Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
◾ The hedge trimmer is overload. ◾ Reduce the load of the machine.
Excessive vibration or
noise.
◾ Dry or corroded blades. ◾ Lubricate the blades.
◾ Blades or blade support is bent. ◾ Replace with a new blade or support.
Contact EGO service center for blade
or support replacement.
◾ Bent or damaged teeth. ◾ Replace with a new blade. Contact
EGO service center for blade
replacement.
◾ Loose blade bolts. ◾ Tighten the blade bolts. Using a
wrench, turn the bolt clockwise to
tighten.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.