TROUBLESHOOTING
PROBLEM
CAUSE SOLUTION SOLUTION
Fail to start.
◾ The battery pack is not attached to the
brush cutter.
◾ Attach the battery pack to the power
head.
◾ No electrical contact between the brush
cutter and the battery pack.
◾ Remove battery, check contacts
and reinstall the battery pack until it
snaps into place.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
◾ The lock-off lever and trigger are not
depressed simultaneously.
◾ Press down the lock-off lever and
hold it, then depress the trigger to
turn on the brush cutter.
Stop working.
◾ The motor is overloaded. ◾ The motor will recover when the
load is removed. For continuous
working, decrease the load on the
power head.
◾ Heavy cutting line is used. ◾ Use standard nylon cutting line with
diameter no more than 2.4mm.
◾ The battery pack or the brush cutter is too
hot.
◾ Allow the battery pack or the power
head to cool until the temperature
drops below 67°C.
◾ The battery pack is disconnected from the
tool.
◾ Re-install the battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack with EGO
chargers listed in this manual.
To Next Page
Loading...
