To Next Page

To Previous Page

56 VOLT LITHIUM-ION REAR MOTOR BIKE-HANDLE BRUCHCUTTER — BC3800E18

PROBLEM

CAUSE SOLUTION SOLUTION

Trimmer head will not

advance line (only

using with trimmer

head).

◾ The motor shaft or trimmer head is bound

with grass.

◾ Stop the machine, remove the

battery and remove the grass from

the motor shaft and trimmer head.

◾ There is not enough line on the spool. ◾ Remove the battery and replace the

cutting line, follow the section “LINE

REPLACEMENT” in this manual.

◾ The trimmer head is dirty. ◾ Remove the battery and clean the

spool, spool retainer and spool base.

◾ Line is tangled on spool. ◾ Remove the battery, remove the line

from the spool and rewind, follow

the section “LINE REPLACEMENT” in

this manual.

◾ The line is too short. ◾ Remove the battery and pull the

lines while alternately pressing

down on and releasing the bumb

knob.

WARRANTY

EGO WARRANTY POLICY

Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.

EGO BC3800E Operator's Manual

Other manuals for EGO BC3800E