OPERATION
WARNING: Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufcient to inict serious injury.
WARNING: Always wear eye protection with side
shields. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING: To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts, making
adjustments, cleaning, or when not in use.
Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts, caps, etc.
Securely tighten all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
APPLICATION
You may use this product for basic felling, limbing, prun-
ing and woodcutting of timber and trees.
NOTICE: The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
FILLING BAR AND CHAIN LUBRICANT
WARNING: Do not smoke or bring any re or ame
near the oil or the chain saw. Oil may spill and cause
a re.
NOTICE: The chain saw is not lled with oil at the time of
purchase. It is essential to ll the tank with oil before use.
The chain is automatically lubricated with chain oil during
operation.
1. Position the chain saw on its side with its oil tank cap
facing towards.
2. Clean the cap as well as the area around and then turn it
counterclockwise to remove (Fig. N).
3. Carefully pour the specically designed oil into the
tank until reaching the bottom of the lter neck.
4. Wipe off any excessive oil and replace the cap.
NOTICE: With upright position, oil should ll the
inspection window. When the oil is no longer visible in the
inspection window, stop use immediately and rell.
ATTACHING/DETACHING THE BATTERY PACK
Fully charge before rst use.
To Attach (Fig. O)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a “click”.
To Detach (Fig. P)
Depress the battery-release button and pull the battery
pack out.
STARTING/STOPPING THE CHAIN SAW
NOTICE:
Before starting the chain saw, check for the oil
level, saw teeth sharpness and properly-working kickback
brake handle. Besides, balanced footing and proper
distance away from the ground are needed.
To Start
1. Pull the chain kickback brake handle towards the
front handle to the operating position (Fig. G).
2. Grasp the front and rear handles rmly, using
both hands.
3. Press down the lock-off button rst, then squeeze
the trigger switch to start (Fig. Q). Release the lock-
off button and continue to squeeze the trigger for
continued operation.
WARNING: Do not attempt to start the saw when the
saw chain is in a cut.
To Stop
1. Release the trigger switch.
2. Push the chain kickback brake handle forward to the
brake position to engage the chain brake (Fig. G).
WARNING: Always remove the battery pack from the
chain saw during work breaks and after nishing work.
Proper Grip On Handles (Fig. E)
◾ Wear non-slip gloves for maximum grip and protection.
◾ With the saw on a rm, at surface, hold the saw
rmly with both hands.
◾ Always grasp the front handle with the left hand and
the rear handle with the right.
◾ The ngers should encircle the handle, with the
thumb wrapped under the front handle.
WARNING: Never use a left-handed (cross-handed)
grip, or any stance which would place your body or arm
across the chain line (Fig. R).
To Next Page
Loading...
Need help?
General
