EGO CS1400E - Page 46

56V LITHIUM-ION CORDLESS CHAIN SAW46
Chain saw does
not cut properly

Insufcient chain tension.

Readjust the chain tension, following
the section: “ADJUSTING THE
CHAIN TENSION”.

Dull chain.

Sharpen the chain cutters, following
the section: “HOW TO SHARPEN
THE CUTTERS”.

Chain installed backwards.

Reinstall the saw chain, following
the section: “REPLACE THE BAR
AND CHAIN”.

Worn chain.

Replace the chain, following the
section: “REPLACE THE BAR AND
CHAIN”.

Dry or excessively stretched
chain.

Check the oil level. Rell the oil tank
if necessary.

Chain not in bar groove.

Reinstall the saw chain, following
the section: “REPLACE THE BAR
AND CHAIN”.
Bar and chain
running hot and
smoking

Check chain tension for over
tightened condition.

Re-tension the saw chain; see the
section: “ADJUSTING THE CHAIN
TENSION”.

Chain oil tank is empty.

Filling bar and chain lubricant.

Debris in guide bar groove.

Clear the debris in the groove.