56V LITHIUM-ION CORDLESS HEDGE TRIMMER—HT2410 23
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Hedge trimmer
dose not work.
◾
The battery pack is not
attached to the hedge trimmer.
◾
Attach the battery pack to the hedge
trimmer.
◾
No electrical contact between
the hedge trimmer and
battery.
◾
Remove the battery, check contacts
and reinstall the battery pack.
◾
The battery pack is depleted.
◾
Charge the battery pack.
◾
The battery pack or the hedge
trimmer is too hot.
◾
Remove the battery pack from the
hedge trimmer and allow the battery or
the hedge trimmer to cool until the tool
and battery pack's temperature drops
below 152°F (67°C).
◾
The front and rear switch
levers are not depressed
simultaneously.
◾
Press the lock-off button first and then
press the switch levers in the front and
rear handle simultaneously.
◾
The blade is jammed.
◾
Remove the battery pack from the tool,
remove the obstruction carefully, then
reinsert the battery and restart the tool.
Excessive
vibration or
noise.
◾
Dry or corroded blades.
◾
Lubricate the blades, following the
instructions in the “LUBRICATING THE
BLADE” section in this manual.
◾
Blades or blade support is bent.
◾
Replace with a new blade or support.
Contact EGO service center for blade
replacement service.
◾
Bent or damaged teeth.
◾
Replace with a new blade. Contact EGO
service center for blade replacement
service.
◾
Loose blade bolts.
◾
Tighten the blade bolts. Use a 1/8" (3mm)
hex wrench and turn the bolt clockwise
to tighten.
To Next Page
Loading...
Need help?
General
