56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HT6500E
11
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Hedge trimmer
doesn’t work.
◾ The battery pack is not attached to
the hedge trimmer.
◾ Attach the battery pack to the hedge trimmer.
◾ No electrical contact between the
trimmer and battery
◾ Remove battery, check contacts and reinstall the
battery pack.
◾ The battery pack is depleted. ◾ Charge the battery pack.
◾ The battery pack is too hot. ◾ Remove the battery pack from the tool and allow it
to cool until the temperature drops below 67°C.
◾ The hedge trimmer is too hot. ◾ Release both switch levers; allow the trimmer to
cool until the temperature drops below 77°C.
◾ The two switch levers are not
depressed simultaneously.
◾ Depress the switch levers on the front and rear
handle simultaneously.
◾ The blade is jammed. ◾ Remove the battery pack from the tool, remove the
obstruction carefully, then reinsert the battery and
restart the tool.
Excessive
vibration or
noise.
◾ Dry or corroded blades. ◾ Lubricate the blades, following the section
“LUBRICATING THE BLADE” in this manual.
◾ Blades or blade support is bent. ◾ Replace with a new blade or support. Contact EGO
service center for blade or support replacement
service.
◾ Bent or damaged teeth. ◾ Replace with a new blade. Contact EGO service
center for blade replacement service.
◾ Loose blade bolts. ◾ Tighten the blade bolts. Using a wrench, turn the
bolt clockwise to tighten.
To Next Page
Loading...
Need help?
General
