EGO Power+ - Line Replacement Procedures; Winding New Cutting Line Onto Spool

56V LITHIUM-ION CORDLESS LINE TRIMMER 23
LINE REPLACEMENT
WARNING:
Always use only EGO authorized replacement nylon cutting line.
Using line other than that specied may cause the line trimmer to overheat or become
damaged.
WARNING:
Never use metal-reinforced line, wire, or rope, etc. These can break
off and become dangerous projectiles.
There are two methods to replace the cutting line:
1. Wind the spool with new line.
2. Install a pre-wound spool.
Wind the spool with new line
WARNING:
To prevent serious personal injury, remove the battery pack
from the tool before servicing, cleaning,
changing attachments or removing
material from the unit.
1. Press the release tabs on the spool
retainer and remove the spool
retainer by pulling it straight out
(Fig. 16).
2. Remove the spool. Use a clean cloth
to clean the inner surface of the
spool base.
NOTICE: Always clean the spool and spool
base before reassembling the bump head.
3. Check the spool retainer, spool and
spool base for wear. If necessary,
replace the wear parts.
4. Take approximately 5m of new
cutting line. Fold the line in half
and then adjust it so that one end
is 10cm longer than the other
(Fig.17).
17
10cm
16
Tab
Tab