EGO Power+ - Page 24

56V LITHIUM-ION CORDLESS LINE TRIMMER24
19
10cm
18
Wind Direction
20
Eyelet
Eyelet
Notch
Notch
5. Hook the folded end of the cutting
line onto either of the slots in the
spool (Fig. 18).
6. Wind the line, in two even and tight
layers, onto the spool. Wind the line
in the direction indicated on the
spool (Fig. 18).
NOTICE: Failure to wind the line in the
direction indicated will cause the bump
head to operate incorrectly.
7. Place the ends of the line in two
opposite notches in the spool, with
approximately 10cm protruding
(Fig. 19).
8. Align the notches of the spool from
which the lines protrude with the
eyelets in the spool retainer and
position the spool in the retainer
(Fig. 20).