7
To House Code, insert a small screwdriver into the
House Code switch slot and remove immediately
when blue light comes on. Repeat this for all
alarms in the system. This must be completed as
quickly as possible to activate the House Code
mode and ensure the system only communicates
with itself and not neighbouring systems.
It is essential that the RadioLINK Bases are House
Coded.
Press and hold the Button to test each Alarm.
Check that the red light is flashing, the horn is
sounding. To ensure the Alarm is communicating
with others check that the blue light comes on for
approx 3 seconds.
Before testing the next alarm allow a minimum
of one minute after the last alarm has stopped
sounding from the previous test.
This guide is for quick referencing only. You must read the user manual thoroughly
before installation and use.
INSERT SCREWDRIVER TO
TURN ON HOUSE CODE SWITCH
BLUE LIGHT
To Next Page
Loading...
Need help?
General
