Ei Electronics Ei168RC - Quick Install Guide

6
2. Quick Install Guide
The Ei168RC RadioLINK Base must be installed by a qualified electrician.
The maximum number of RF Alarms in each system is 12. If your system has more than
12 Alarms please consult your supplier or contact tech support (see back page).
Install each RadioLINK Base in the centre of the
ceiling at least 0.30m from light fittings as per
the Smoke/Heat Alarm instructions and connect
to nearest mains circuit.
Slide Alarm on to the Ei168RC RadioLINK Base.
This will automatically activate the rechargeable
back-up cells in the base.
Repeat this procedure for all Alarms in the system.