1. QUICK INSTALLATION GUIDE
For use only with Ei Electronics Easi-fit Mains Powered Smoke & Heat Alarms. The
Ei168RC RadioLINK Base must be installed by a qualified electrician.
1.1) Install each RadioLINK Base in the centre of the ceiling at
least 0.30m from light fittings (as per the smoke/heat alarm
instructions) and connect to nearest mains circuit (see page 3).
1.2) Slide alarm on to the Ei168RC RadioLINK Base. This will
automatically activate the rechargeable back-up cells in the base.
Repeat this procedure for all alarms in the system (see page 5).
1.3) To House Code, insert a small screwdriver into the House
Code switch slot of each unit in succession. This must be
completed as quickly as possible (within 15 minutes) to activate
the House Code mode and ensure the system only
communicates with itself and not neighbouring systems (see
page 6). It is essential that the RadioLINK Bases are House
Coded.
1.4) Button test each alarm to ensure that they are all
communicating.
3
This guide is for quick referencing only. Yo u must read the user manual thoroughly before
installationanduse.
To Next Page
Loading...
Need help?
General
