user to Locate the triggering alarm both when all
units are sounding and when they have previously
sounded (memory function - useful for
troubleshooting), Hush any nuisance alarms and
Test the system from a remote location.
3. INSTALLATION
WARNING: Mains operated products should be
installed by a qualified electrician as per the
Requirements for Electrical Installations published as
IEE Wiring Regulations – BS7671 current edition.
Failure to install this unit correctly may expose the user
to shock or fire hazards. This unit is not waterproof and
must not be exposed to dripping or splashing.
Up to twelve Ei168RC RadioLINK Bases can be RF
interconnected in one system.
1. Select a location complying with the advice in the
Smoke/Heat Alarm instruction leaflet.
2. Disconnect the AC mains supply from the circuit
that is going to be used.
3. Carefully align the RadioLINK Base and screw into
place as shown in Figure 1.
(It is advisable at this time to
use only one screw (as shown) as it allows the base to be
Figure 1
Figure 2
5